When your car's air conditioner isn't cooling anymore — or worse, blowing hot air — it can make for an uncomfortable ride on a warm day. the solution could be a simple one, but it could also require a complex repair that would be risky to attempt at home.
There are two basic types of problems you can experience with your car's air conditioning. each one will have different symptoms, and different potential solutions. choose your issue below to see more details.
Common reasons a car's ac isn't cooling
While there are a variety of reasons your car's air conditioning might not be operating at top performance, the most common are a refrigerant leak, an electrical climate control issue, or a problem with the air conditioning compressor. each of these can cause the ac to blow lukewarm or hot instead of cold air.
A/C Refrigerant Leak
Your car's air conditioning uses refrigerant, a fluid designed to vaporize at a low temperature, to cool the air before it blows through the vents into the passenger compartment of the vehicle. If that refrigerant is leaking from somewhere in the AC system it will become less effective at cooling the air before it leaves the vents.
A leak like this can be the result of a faulty component within the system, such as the compressor, evaporator or hoses. or, it can just be a sign of age for an older vehicle, since the parts and hoses use rubber seals that naturally tend to wear over time, causing the refrigerant to leak.
Accidents and other damage can also cause refrigerant leaks. since the ac condenser is located in front of the radiator, it's susceptible to damage from flying road debris and other small front-end impacts. another possibility is that ac hoses and pipes can rub against other parts while you drive, eventually causing a leak.
Air Conditioning System
Diagnosing an ac refrigerant leak
One way you can verify this is by listening to the ac compressor. you should hear an audible click from the engine area when the ac is turned on. this is the compressor clutch engaging, which allows the compressor to operate.
When a system is low on refrigerant, the compressor will cycle on and off frequently. if the system is very low, the compressor will not turn on at all. The system must be checked for leaks; any leak found should be repaired and the system properly evacuated and recharged.
How to find a leak (when the engine is off):
listen for a hissing sound from the ac system
look for oil residue from or around ac hoses and pipe fittings
inspect the condenser for road damage (in front of the radiator)
use a special tool that can detect ac refrigerant gas
use an infrared light to detect ultraviolet dye in the refrigerant (if previously added)
Solution: if a specific part of the ac system is the culprit, the repair will involve an inspection and repairing or replacing the offending part. if enough refrigerant fluid has already been lost, a full A/C Recharge will also likely be necessary in order to flush the system and replace it with the right amount of refrigerant to function properly and keep air blowing cold.
note: refrigerant is a dangerous and toxic chemical, and should be kept from escaping into the atmosphere. because of this risk, only trained technicians with the proper equipment should perform air conditioning repairs.
Climate control electrical issue
The buttons, knobs and control screens that you use to adjust the temperature in your vehicle tell an AC/Heater Control Module — basically a computer — to pass instructions to the heating and cooling system.
Just like with any electrical tool or appliance, this component or the parts that support it, such as electrical wiring, can break down or fail for a variety of reasons. as a result, your car's ac could start to perform inconsistently, or even stop working altogether.
Solution: Due to the complex nature of the electronics in this system, an experienced and trained technician will need to evaluate the components to diagnose the true root cause, and ultimately repair or replace the faulty parts. You can help by clearly communicating and demonstrating the symptoms with the shop before they start working to fix this issue.
AC compressor problem
The compressor is an extremely important part of your car's air conditioning system. its purpose is to move refrigerant through the system, and compress low-pressure refrigerant gas into high-pressure refrigerant gas before passing it to the ac condenser.
If this crucial component starts to break down, it will mean refrigerant can no longer be reliably moved through the system, so air blowing through the vents can't be cooled.
AC Compressor
diagnosing an ac compressor problem
The compressor must turn on for the ac system to work. the compressor belt and the electrical circuit to the compressor must be in good condition. if the belt is ok, the mechanic will check for proper power supply to the compressor. if that checks out, then the compressor has likely failed and may need replacement.
When the ac compressor is replaced, you may need a few additional items:
replace the ac accumulator or receiver dryer (this part helps to remove moisture from the refrigerant)
if the compressor failed internally, then metal shavings may have been distributed throughout the system. this would require a system flush and potentially the replacement of other damaged parts.
when replacing the ac compressor, the drive belt should be replaced if it shows any sign of wear
If the power supply is not present, the problem might be:
defective wiring or fuse
bad pressure switch
bad control module
ac operation criteria has not been met:
low refrigerant pressure (low refrigerant or low pressure switch)
outside temperature too low (ambient temperature sensor)
high refrigerant pressure (engine temperature too high/blockage in refrigerant system)
engine at full throttle (throttle position sensor)
Solution: an inoperative compressor is normally due to low refrigerant or loss of power to the compressor. however another solution may involve an AC Compressor Replacement.
Common reasons for no airflow from the vents
Air flow is created by a "blower motor" and directed through passageways in the dashboard using flaps and doors. the blower motor and the passageway flaps and doors can fail causing airflow issues:
Blower motor
The blower motor is an electronically controlled fan that blows air into the passenger compartment. the motor can stop working for several reasons, all which cause the flow of cool air to cease. There are a two main reasons this occurs: the motor or the system controlling it have failed.
Cable operation
These control systems are quite simple. you have a lever or knob, a cable, and a cable-controlled door or flap. When you move the lever or knob, the cable opens and closes the door, changing the direction of the airflow. the problem is usually broken cables, but the controls can break, as well.
Vacuum operation
These systems use vacuum to operate a vacuum motor (or diaphragm), which in turn operates a door or flap. the controls can be mechanical or electronic, but the system will use vacuum hoses to transmit vacuum to the vacuum diaphragms. most of the time, the problem is a vacuum leak.
Typically, when these systems lose vacuum, the airflow is automatically directed to the windshield — this may be constant or it can occur just when you're driving. if the airflow stops when you're accelerating, this is likely due to a vacuum leak.
Electrically operated
Most newer vehicles have an electrically controlled system, which uses electric motors to change the door position. a control module will send a voltage signal to the appropriate electric motor, which opens and closes the door accordingly. some vehicles can have problems with the motors, while others have control module issues. whatever the cause, these systems take electrical diagnostic skills to be able to diagnose and repair.
References: https://repairpal.com/symptoms/car-ac-not-working
Comments